Installation manual
© Hills Industries 2009 Page 33
Segment 4
(1)
On if Fail To Communicate report enabled
2
On if Log Full report enabled
(3)
On if Auto-test report enabled
(4)
On if Start/End programming report enabled
(5)
On if End Download report enabled
(6)
On if Sensor Low Battery report enabled
(7)
On if Sensor Missing report enabled
8
On if Expander Module (number) to be reported via the Contact I.D. report
Segment 5 new
(1)
On enable Lost Clock service light
2
On enables Zone Doubling
3 new
On disables all hardwired zones on the main board.
Must cycle power on/off to disable or re-enable hardwire zones.
4
On will enable all Dual End of Line (DEOL) resistors on all zones
5
On will prevent force armed zones to report bypass
6
On enables Silent Exit option
7 new
Reserved
8
On will Auto Partial Arm Area 1
Segment 6 new
1 new
Enable Two Wire Smoke
2 new
Reserved
3 new
Enable Zone Inactivity Time In Hours. Default is off = days.
4 new
Reserved
5 new
Enable DC Operation
6 new
Reserved
7 new
Enable Steady (Temporal) Siren. Default is off = Evacuation Siren for fire events.
8 new
Reserved
Segment 7 new
1 new
Reserved
2 new
Reserved
3 new
Reserved
4 new
Reserved
5 new
Reserved
6 new
Reserved
7 new
Reserved
8 new
Reserved
System Option Descriptions
Auto Partial Arm Area One
If enabled, area one will auto partial arm at the auto-arm time. If this option is enabled, area one cannot be auto-armed in
the full mode (see F 22 – Seg 5 – Op 8).
Battery Testing
The Hills Reliance can test for the presence of the battery every 12 seconds (see F 22 – Seg 2 – Op 5).
The Hills Reliance will also test the battery condition at disarm, once per 24 hour cycle.
Box Tamper
If enabled, the Hills Reliance will use the N/C Box Tamper pins provided on the main board (see F 22 – Seg 2 – Op 8).
Dual End Of Line (Zone Tamper)
If enabled, the Hills Reliance will monitor all zones except types 17 and 28 for Dual End Of Line. A short or open circuit on a
DEOL will set zone tamper alarms. Refer to the terminal wiring diagram for more detail (see F 22 – Seg 5 – Op 4).
To reset tamper condition press []-[7] on code pad.