User manual

VIEW ZONE STATUS

Step 1 Press r • . The LCD Screen will display the zone status.

Step 2 Use the up and down scroll keys to browse through the descriptions. The

LCD Screen will display the list of all zones in sequential order by zone

number.

Step 3 Press [#] to exit this function.

SETTING THE KEYPAD TONE

Step 1 Press r 0 . Keypad is now in the “Adjust Tone” mode.

Step 2 Press the • up scroll key located

on the right side of the display to

adjust the keypad sounder to higher

tones.

Step 3 Press the – down scroll key to adjust the keypad sounder to lower tones.

Step 4 When the desired tone is reached, press # to set this tone and exit from

the “Adjust Tone” mode.

VIEW ALARM MEMORY

Step 1 Press r 3 to display the zone(s) on the keypad that created the last

alarm.

Raise tone º

Lower tone º

arm Memory 1

ZONE 1

Step 2 The LCD Screen will display the

zone description for those zones.

Step 3 Press [#] to exit the alarm memory.

TEST FUNCTION (Optional, if programmed)

If programmed, this function will perform a battery test, communicator test, and/or a

siren test. No alarms will be sent, and no reports will be sent unless a

communicator test is performed, in which case a test signal will be sent.

Step 1 Press r 4 4 . The test will be performed as programmed.

Step 2 If the siren test is performed, enter a user code to silence the siren.

Hills LCD Keypad