User manual

DISPLAY TEST FUNCTION

This function will perform a test of the LCD display. No alarms or reports will be

sent.

Step 1 Press r 4 5 . The test will be performed and all of the display

pixels and LED indicators will flash until another key is pressed.

Step 2 Press any key to end the test.

LIGHT CONTROL FOR X-10 DEVICES (Optional, if programmed)

This menu allows you to control up to ten X-10 devices from each keypad.

Step 1 Press r 4 6 . The LCD screen will prompt you to “Select Light

Number 0 - 9”.

Step 2 Enter the number of the X-10 device you want to control. The LCD screen

will show the light number on the left. On the right side of the display it will

prompt you to turn the light (X-10 device) “On” or “Off”.

Step 3 Press the • to turn the X-10 device “On” or press the – to turn the X-

10 device “Off”.

Step 4 The LCD screen will again prompt you to “Select Light Number 0 - 9”.

Step 5 Repeat Steps 2 and 3 until complete.

Step 6 Press # to exit from the X-10 menu.

CHANGE LANGUAGES

This function allows you to switch between the two languages programmed in your

keypad. NOTE

: You must exit any other function mode before attempting to

change languages.

Step 1 Press r 4 9 . The LCD keypad is now toggled to the second

language.

Step 2 Repeat Step 1 to revert to the first language.

Hills LCD Keypad