User manual

 To disarm all of these areas, press • .
 To arm all of these areas, press – .
 To toggle a single area between the armed and disarmed conditions, press
[À][Area number]. For example: If Area 4 is armed, [À] [4] will disarm Area
4. If Area 4 is disarmed, [À] [4] will arm it.
 Press [STAY] during the exit delay to bypass all interior zones in the exit
delay.
 To control the individual areas, refer to the following section.
 OPERATING INDIVIDUAL AREAS IN THE MULTI-PARTITION MODE
Enter a code that is a valid arm/disarm code for the area you wish to operate. The
following display will appear on the LCD screen.
Only the areas authorized by this code will
appear.
To toggle between the armed and disarmed states of an individual area, press [r]
[Area number].
To operate an individual area, enter the number of the partition you wish to operate.
The LCD keypad will now operate as a single area keypad. All keys and functions
entered will affect this individual partition only. The lights and display represent the
status of that partition only. The word "System" will be replaced with the word
"Area #". The following is an example of this feature. To exit this screen, press [#].
12-4—78 Disarm º
--3-56-- Arm º
Area 5 Ready
Type code to arm
Area 5 is selected and Area 5 is ready to
arm. To exit the individual partition mode,
enter [#]-[#].
 SILENCING ALARMS IN THE MULTI-PARTITION MODE
If the keypad is sounding an alarm or the siren is running, it can be silenced by
entering a code with the authority for the area(s) that are in alarm. NOTE: The
[EXIT], [BYPASS], and [STAY] keys will only work if an individual partition is
selected.
Hills LCD Keypad
19