.INTRODUCTION Package Contents POWER ADAPTOR User’s Manual BASE Unit Wireless Headset EAR-HOOK HEADSET & HEADBAND TELEPHONE CONNECTION CORD USB CABLE (Optional) 2.
- Fit the headband or ear-hook on the headset - Adjust the boom arm of your headset so that the microphone is positioned in 3. Base Unit Base Top Base Bottom the direction of your mouth, as close as possible to your mouth. PC/TEL Selection Microphone Volume Mic.
4. LED & Audio indicator 5. Setting up the BASE Diagram 1 (Desk phone with HEADSET port) Battery indicator TEL indicator Bluetooth indicator PC indicator Charging Status LEDs status Charging Battery Indicator : ‘Blinking’ 3 sec-ON, 1sec-OFF Full Charged Battery Indicator : ‘ON’ Low Battery Battery Indicator : ‘Blinking’ 0.5 sec-ON, 0.
7. Electronic Hook Switch (optional extra) (Desk phone with DL-570 LIFTER) The DL-570 remote handset lifter manually lifts the desk phone handset to The unit enables you to answer and end calls remotely by using its built-in electronic make or answer a call. hook switch (EHS). EHS of this unit is only compatible with certain telephone systems - Refer to the DL-570 installation guide supporting EHS. ★ EHS is only compatible with certain telephone systems.
on the headset to a lower setting. When Bluetooth call talking, the blue LED is blinking with different period. To finish a call, press the hook button on headset. 5. EHS doesn’t work with the telephone ☞ Make sure the telephone is compatible with the wireless headset. Refer to the EHS guide. After finishing, the blue LED is turned off and previous mode LED will be turned on.
Compliance Statement (Part 15.19) This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2. This device must accept any interference received, including interference that may cause undesired operation. ㅤ ㅤ Warning (Part 15.21) Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
