User's Manual

Install the FiberJACK ONT
Zhone 2800 Series FiberJACK ONT Hardware Installation Guide
41
c The fiber must then be properly terminated with an SC/APC
connector for GPON ONT models or with an SC/UPC connector for
GE ONT models.
4 Connect power and the fiber
a Remove the wallbox cover (if present)
b Remove the faceplate from the base assembly of the FiberJACK ONT
by unscrewing the two security (hex-pin) screws with a #T10
Security Torx screwdriver or equivalent
c Slide the faceplate straight down (toward the GE LAN ports)
approximately 1/4" until you feel the two retention latches un-snap
d Verify that the GE LAN port holes in the faceplate are clear of the
RJ45 connectors, so that the faceplate may be lifted straight up and
off
e Connect Power to the FiberJACK ONT
–For AC powered ONTs
Always disconnect power before conducting the installation on
AC circuits.
Put the ONT Power Switch on the lower left side into the OFF
(down) position using a pen cap, paper clip or small slot
screwdriver.
Connect the ONT Power Pigtail (attached to the FiberJACK
ONT) to the AC Power Pigtail coming from the wallbox.
Fold and tuck the excess wiring back into the wallbox
–For DC powered ONTs
Put the ONT Power switch on the lower left side into the Off
(down) position using a pen cap, paper clip, or small slot
screwdriver.
PoE source:
When powering from a PoE source, plug the terminated CAT5 or
CAT6 cable into the RJ45c connector on the back of the
FiberJACK ONT, and fold the excess cable into the wallbox.