User's Manual

Zhone 2800 Series FiberJACK ONT Installation
44 Zhone 2800 Series FiberJACK ONT Hardware Installation Guide
d Verify that the red Alarm LED turns on, and remains on until the
GPON link successfully ranges or until the active Ethernet WAN
connection is up (for Active Ethernet ONTs)
If the GPON link does not range (or the GE link does not come up)
troubleshoot the installation in conjunction with the staff responsible
for OLT and ONT provisioning.
e Once the Alarm LED has turned OFF, insert a second mounting screw
into the lower mounting hole of the FiberJACK ONT base assembly
and tighten it completely while ensuring that the FiberJACK ONT is
properly leveled.
f Tighten the top mounting screw so the FiberJACK ONT is securely
fastened to the wall.
6 Attach the FiberJACK ONT faceplate
a Place the FiberJACK ONT faceplate over the mounted ONT base
assembly and push upwards approx 1/4" until you feel the two
retention latches snap together.
b Secure the faceplate using the two security (hex-pin) screws with a
#T10 Security Torx screwdriver or equivalent.
7 Connect subscriber services
Connect subscriber Ethernet services
The FiberJACK provides up to four GE LAN ports using RJ45 modular
jacks for Ethernet connections. These Ethernet connections can be used to
deliver any packet services including IPTV, data, and VoIP.
For Ethernet services, connect a Category 5 or a Category 6 cable to an
RJ45 interface as shown in Figure 17.
Figure 17: The RJ-45 Ethernet ports.