User's Manual

Zhone 2800 Series FiberJACK ONT Installation
46 Zhone 2800 Series FiberJACK ONT Hardware Installation Guide
Providing power to the wallbox
WARNING! Installing electrical wires, especially for the AC
installations, may be hazardous and could lead to serious
injury or possibly death. Disconnect power before conducting
the installation. Take all proper precautions or have a
qualified electrician perform the tasks for installing electrical
wiring.
Providing power to AC powered ONTs, new wallbox
For AC powered ONTs, new wallbox
1 Turn off any electricity running to the wallbox circuit.
2 Check that the wallbox is mounted securely (new or old work style
wallbox). A plastic or a metal wallbox can be used.
3 Non-metallic ("Romex") or flexible metal-clad ("BX") AC cabling should
be used per local electrical code requirements.
4 Strip back the outer sheath of the AC cable wires in the wallbox, exposing
the three conductors (Hot, Neutral, and Ground) inside.
5 Trim the length of the Hot, Neutral, and Ground conductors from the
outlet box to have approximately 4 to 5 inches of working length.
6 Strip the insulation back from the ends of the Hot, Neutral and Ground
conductors to expose about 15mm (0.6") of bare copper wire.
7 Add two lengths of heat-shrink tubing — 30mm and 40mm diameter —
over the end of the wires and slide back to make the connection. Have the
larger diameter piece be closer to the connector.