User's Manual

Providing power to the wallbox
Zhone 2800 Series FiberJACK ONT Hardware Installation Guide
47
8 Connect the female, 3-pin, terminal-style connector to the stripped ends
of the AC wires prepared in Step 6.
Make sure that the three AC wires are connected to the correct pins by
checking the wiring chart shown in Power connections on page 50.
9 Pull the heat-shrink tubing down which is closest to the connector and
pull it down and stretch it so it will cover the terminal screws, then apply
appropriate heat to shrink the larger diameter piece of tubing to the
connector.
Pull the second smaller diameter heat-shrink tubing down over the end of
the other molded tubing, then apply appropriate heat to shrink the smaller
diameter piece of tubing over the end of the larger diameter piece to
present a fully-insulated AC Power pigtail connection.
This connection can be pushed into the wallbox and a wallbox cover
added if the FiberJACK ONT will be installed at a later time.
Note: The AC Powered ONTs have an ONT Power Pigtail with a
male connector designed to connect to the female AC Power
Pigtail connector.