User's Manual

Zhone 2800 Series FiberJACK ONT Installation
48 Zhone 2800 Series FiberJACK ONT Hardware Installation Guide
Providing power to AC powered ONTs, replacing an outlet in
an existing wallbox
1 Turn off any electricity running to the wallbox.
2 Check that the outlet has sufficient space available inside for mounting
the FiberJACK ONT
The wallbox should have 3" (70mm) of unimpeded depth to allow for
splices and connectors.
3 Partially remove the outlet from the wallbox, disconnect the AC wires
attached to it, and label them for identification if necessary.
These wires need to have approximately 4 to 5 inches of working length.
4 If necessary, strip the insulation back from the ends of these Hot, Neutral
and Ground wires to expose about 15mm (0.6") of bare copper wire.
5 Add two lengths of heat-shrink tubing — 30mm and 40mm diameter —
over the end of the wires and slide back to make the connection. Have the
larger diameter piece be closer to the connector.
6 Connect the female, 3-pin, terminal-style connector to the stripped ends
of the AC wires prepared in Step 4.
Make sure that the three AC wires are connected to the correct pins by
checking the wiring chart shown in Power connections on page 50.
7 Pull the heat-shrink tubing down which is closest to the connector and
pull it down and stretch it so it will cover the terminal screws, then apply
appropriate heat to shrink the larger diameter piece of tubing to the
connector.