User's Manual

66xx/67xx Router Users Guide 105
Capability
Bitswap Enable
SRA (Seamless Rate Adaptation) Enable
SESdrop Enabled
PhyR Upstream Enabled
PhyR Downstream Enabled
Do not change these settings unless so directed by your ISP.
AuxFeature
G.INP Upstream
G.INP Downstream
Do not change these settings unless so directed by your ISP. For G.INP to work the option must
be enabled on the other side of the connection.
G.Vector is enabled by default. The configuration of G.Vector on the gateway is controlled by the
CO device.
DSL Advanced Settings
Do not change the DSL Advanced Settings unless so directed by your ISP.
To view the DSL Advanced Settings screen, click Advanced Settings button on the DSL
Settings screen.
The test mode can be selected from the DSL Advanced Settings page. There are five test modes
between the router and your ISP:
• Normal test: Puts the router in a test mode in which it only sends a Normal signal.
• Reverb test: Puts the router in a test mode in which it only sends a Reverb signal.
• Medley test: Puts the router in a test mode in which it only sends a Medley signal.
• No Retrain: In this mode the router will try to establish a connection as in normal mode, but
once the connection is up it will not retrain if the signal is lost.
• L3: Puts the router into the L3 power state.
To run a test:
1. Select a test mode and click Apply.