User's Manual

66xx/67xx Router Users Guide 35

Chapter 3 The Web User Interface

The 6xxx gateways have a Wide Area Network (WAN) connection which connects to your

Internet Service Provider (ISP) via a DSL, Ethernet interface, or a 3G connection. The Local Area

Network (LAN) connections are where you plug in your local computers to the gateway. The 6xxx

also has a wireless interface. The gateway is normally configured to automatically provide all the

PCs on your network with Internet addresses.

Your gateway may be pre-configured with your ISP configuration to ease your installation.

Please contact your ISP if you need information on how to connect the gateway to your ISP. To

set up your gateway with a basic configuration required by your service provider, you can use the

Quick Setup form the top of the navigation bar. In order for this to work, all other WAN services

must first be removed. To remove services, from the top navigation bar select Quick Setup.

If you connected a PC (rather than a hub or a switch) directly to the gateway, your LAN consists

of that PC. You may also create connections for various protocol options by creating new

connections.

To configure your device you will first need to log in to the gateway.

Note: Before configuring your gateway, make sure you have followed the instructions in Chapter

2, Hardware Installation and PC Setup on page 30. You should have your PCs configured for

DHCP mode (if your gateway will be), and have proxies disabled on your browser. If you see a

enabled in your browser. Also, if you do not get the screen shown below, you may need to delete

your temporary Internet files.

This section explains how to log in to your gateway.

1. Launch your web browser.

2. Enter the URL http://192.168.1.1

in the address bar and press Enter.

A login screen like the one below will be displayed after you connect to the user interface.

3. Enter your user name and password, and then click on OK to display the user interface.

The default admin user name / password is admin / adminXXXXXX, where XXXXXX is the

last six digits of the serial number of the unit; both user name and password are case

sensitive.