Installation Guide 7010 Auto Cutter –1–
© August 2010 DASCOM Europe GmbH
Installation Guide CAUTION: For use by service representatives! (1) Check to make sure that the printer’s power switch is turned off then disconnect the power cord. (2) Open the top cover and lift the thermal printhead and sensor arm. Sensor arm Thermal printhead Head open lever (3) Sensor arm open lever Remove the front top cover from the top cover. (2 screws) Note There is a hook on the front top cover. Be careful not to bend the hook while removing the front top cover from the top cover.
(5) Remove the operation panel on the front of the printer. (2 screws) When doing this, remove the flexible cable that is connected to the operation panel. Flexible cable (6) Remove the front right cover on the front of the printer. (2 screws) (7) Remove the pulley cover (black) that is on the right front part of the printer. (1 screw) Using nippers, cut out the notch on the pulley cover that you have removed.
(8) Remove the front center cover. (2 screws) (9) Remove the front cover from the front center cover that you have removed. (2 screws) Note The front cover that you have removed is used when the auto-cutter unit has been removed, so store it carefully. Front cover (10) Attach the pulley cover (black) that you removed at step 7 in its original position. (11) Connect the connector of the auto-cutter unit to the relay printed circuit board as shown in the figure.
(12) Insert the claw on the right side of the auto-cutter unit into the notch on the printer, then fix it in place with the attached screw (1). Be sure to pass the cable between the metal plate and the pulley cover. Metal plate Pulley cover Notch Claw (13) Attach the front center cover from step 9 in its original position. (2 screws) (14) Attach the front right cover removed at step 6 in its original position. (2 screws) (15) Attach the operation panel removed at step 5 in its original position.
–7–
DASCOM REPRESENTATIVES GERMANY DASCOM Europe GmbH Heuweg 3 D-89079 Ulm Deutschland Tel.: +49 (0) 731 2075 0 Fax: +49 (0) 731 2075 100 www.dascom.com UNITED KINGDOM DASCOM GB Ltd ViewPoint, Basing View, Basingstoke, Hampshire RG21 4RG, England Phone: +44 (0) 1256 481481 Fax: +44 (0) 1256 481400 www.dascom.com RUSSIA and CIS DASCOM Europe GmbH Representation Moscow Leninsky Prospekt 95a, Office 322 119313 Moscow, Russian Federation Phone: +7 (495) 984 70 65 Fax: +7 (495) 984 56 42 www.dascom.