User Guide User guide

Trouble-Shooting
7-3
Printing is vertically mis-
aligned (jagged).
Use the printer's vertical alignment function to check
the vertical print alignment. If necessary, adjust the
print alignment. See the section “Checking Vertical
Alignment” in this chapter.
The top margin is wrong. The top margin is the sum of the printer’s top-of-form
setting, the software-specified top margin, and the
printer’s TOP-MRGN setting. Proceed as follows:
 Make sure that the top-of-form setting is correct.
The factory default is 0 mm (0 inch). See the sec-
tion “Adjusting Top-of-Form Origin” in Chapter 5.
 Check the software-specified top margin. Refer to
your software documentation.
 Check the printer’s TOP-MRGN setting. See the
section “Changing Macro 1 and Macro 2 Options”
in Chapter 5.
Lines are double spaced
instead of single spaced.
Check the line spacing setting in your software.
Change the LINE MODE setting in the printer Set-
Up mode to LF=LFCR=CR. See the section “Chang-
ing Macro 1 and Macro 2 Options” in Chapter 5.
The printer overprints on the
same line.
Change the LINE MODE setting in the printer Set-
Upmode to CR=LF+CR. See the section “Changing
Macro 1 and Macro 2 Options” in Chapter 5.
The next print line starts
where the previous line
ended instead of at the left
margin.
Change the LINE MODE setting in the printer Set-
Upmode to LF=LF+CR. See the section “Changing
Macro 1 and Macro 2 Options” in Chapter 5.
The printer overprints on the
same line while the next
print line starts where the
previous line ended instead
of at the left margin.
Change the LINE MODE setting in the printer Set-
Upmode to LFCR=LF+CR. See the section “Chang-
ing Macro 1 and Macro 2 Options” in Chapter 5.
Problem Solution