User Guide User guide

Setting up the printer
2-14
Removing the shutter
Attaching the shutter
CAUTION:Take care not to use excessive force when pushing the back of the shutter
toward the front of the printer. Otherwise, the shutter tabs may be dam-
aged.
To reattach the shutter, tilt the shutter and insert one of its convex parts
into the installation hole of the printer, and then insert the other part in
the other hole. After inserting both convex parts, lower and push the
shutter in to its original position.
1. Open the shutter.
2. Gently push the back end of the
shutter toward the front of the
printer.
3. While holding the shutter in the
position described in step 2, rotate
it in the manner shown in the
Shutter
(a)
Mounting slots
Tab s
Shutter
5. Tilt the shutter and pass the shutter
tabs through the mounting slots,
starting with the slot on side (a)
shown in the figure on the left. The
order in which the shutter tabs are