User Guide User guide

Paper Handling
3-9
5. Adjust the right paper guide to the width of paper. Insert the paper into the cut
sheet stand. Make sure that the bottom edge of the paper engages snugly with
the platen. Thepaper will automatically advance to the top-of-form position if
the Single Sheet Load option of the Set-Up mode is set to Automatic.
NOTE: The factory setting for the Single Sheet Load option is automatic loading, two
seconds after paper detection. If you set this option to manual, you will have
to press FF/Load to feed the paper.
6. If you want to slightly adjust the Top-of-Form position, the first line on which
printing can start, adjust the Top-of-Form position of the paper using control
panel buttons. Press the Set-Up/Quit (Pause) button and the two Top buttons at
the same time. The M1/M2 indicator flashs alternately with the DEC and PPX24
indicators, indicating Top-of-Form Adjustment mode. Press the
 button or the
 button. The paper will move forward or backward in 1/60-inch increments.
Press the Set-Up/Quit button after adjusting the position. Note that this adjust-
ment is temporarily saved. It will not be active at next power-up of the printer.
For permanent adjustment, see the section “Feeding and Positioning Paper” later
in this chapter.
Loading a sheet of paper