User Guide User guide

Paper Handling
3-16
Unloading Continuous Forms
To unload continuous forms:
1. Make sure that the paper select lever is set to the rear position.
2. Press the Park button. The continuous forms paper is retracted to the park posi-
tion. If the paper cannot be retracted in one operation, continue to press the
Park button until the paper is parked.
NOTE: The printer can retract continuous forms paper a maximum of 55.8 cm (22
inches) per operation.
3. To remove the paper, raise the tractor paper holders and lift out the paper.
Installing the Tractor Unit
Install the tractor unit by following the procedure below if it happens to be disen-
gaged from the studs.
1. Turn off the printer.
2. Remove the cut sheet stand and open the acoustic cover.
3. Hook the notch of the tractor unit against stud 1, and then rotate the unit down-
ward so as to set the other notch onto stud 2.
Tractor unit installation
Stud 1
Stud 2
Stud 1
Stud 2
Acoustic cover