User Guide User guide

Using Set-Up Mode
5-11
Points to Remember
 We recommend that you use continuous forms paper for printing in the Set-Up
mode because the output will exceed a single page. To load paper, use the FF/
Load button. To adjust the line position of the paper in the Set-Up mode, use the
platen knob.
 Whenever you enter the Set-Up mode, short help menus are printed at the top of
the page. Help menus are also printed when you select the TESTS function. Use
the help menus for quick reference while in the Set-Up mode.
 When printing the options and values for each function, you can move either for-
ward or backward in the option list. To move forward (print the next option), press
the
 button. To move backward (print the previous option), press the  button.
You can skip printing the value list for the undesired options by pressing and
holding down these buttons.
 While in the <FUNCTIONS> menu or when selecting a function that contains op-
tions and selectable values, press the Exit/Save button to reprint the <FUNC-
TIONS> menu. In this case, the red cursor is positioned beneath SAVE&EXIT.
 A bolded (overprinted) value indicates that it is the current setting. An underlined
value indicates a selected setting.
 While in the Set-Up mode, you can use the PRINT function to print out a list of
the currently selected values. (See the next section for details.)
 To exit the Set-Up mode and permanently save your changes, select the
SAVE&EXIT function. For details, see the section “Save Settings and Exit Set-
up mode” later in this chapter.
 To exit the Set-Up mode and temporarily use your changes, press the Set-Up/
Quit button. Your previous power-on settings will be active when you turn the
printer on again.