User Guide User guide

Using Set-Up Mode
5-29
<BIT&PARITY>
7 EVEN
7 ODD
7 SPACE
7 MARK
8 EVEN
8 ODD
8 NONE
Setting of data format for the serial interface
Number of data bits Parity bit
7Even
7Odd
7 Space *
7 Mark *
8Even
8Odd
8None
* The mark is logical 1. The space is logical 0.
<BUFFER CTL>
(Buffer Control)
DTR
XON/XOF
Setting of data transmission buffer control for
the serial interface.
The Data Terminal Ready signal is used.
The DC1 and DC3 codes are used.
<DISC FAULT>
(Disconnect on
Fault)
NO
DROP DTR
PULSE DTR
Specify the disconnect control of the interface
when a fault condition occurs.
DTR is kept as it was.
DTR is turned low and fixed.
DTR is turned low for five seconds and
returned to the original state.
<AREA CTL>
(Area control)
YES
NO
Specifies the detection of the right and left
edge. In case of YES print data on the left and
the right of the edges will be cut.
Detect the right and left edge.
Does not detect the right and left edge.
<GATHER CTL>
(Gather control)
YES
NO
Control gathering
Does not control gathering.
<TEROFF CTL>
(Tear off control)
PRCISIN
SPEED
Backward with precision.
Backward fast.
<SKIP CTL>
(Skip control
YES
NO
Do skip.
Do not skip.
Install Options Values Description