User Guide User guide

Using Set-Up Mode
5-30
Adjusting Top-of-Form Origin
Print positions often change gradually when you use the printer over long periods of
time. The ADJUST function allows you to adjust these positions by fine-tuning the
Top-of-Form origin.
The following table describes the ADJUST options and values. Options are listed in
the order they are printed.
Adjust Options and Values
Overprinted values are the factory settings.
Adjust Options Values Description
<FNFOLD ADJ>
(Fanfold Adjustment)
##/60 IN
Adjust the Top-of-Form origin for continuous
forms in increments of 1/60 inch (0.42 mm)
from the physical top of the page.
-10 to 10 (0)
Number of 1/60 inches
<MNUAL ADJ>
(Manual Adjustment)
##/60 IN
Adjust the Top-of-Form origin for single sheets
in increments of 1/60 inch (0.42 mm) from the
physical top of the page.
-10 to 10 (0)
Number of 1/60 inches
<RESVD 1> Reserved
<RESVD 2> Reserved
<MNUAL ADJ2> -21/360
-14/360
-7/360
0/360
7/360
14/360
21/360
GRAPHIC
Accumlative LF adjustment for Cut Sheet