Marketing Materials

File E81296 Vol. 1 Sec. 503 Page 2 Issued: 2015-06-05

and Report

CONSTRUCTION DETAILS:

Section General – The following construction items are described in the

Section General:

Mechanical Assembly Corrosion Protection

Markings Instruction Manual

Date Code Important Safeguards

Carton Markings Polarization Instructions

For details of the construction, refer to the following photographs and

descriptive pages.

Canadian References – In this report, CN denotes that the component is

CUL or CSA Certified. If the unit does not bear the CUL Mark, the CN

reference should be disregarded.

Spacings – Minimum 1.6 mm through air and over surface spacings shall

be maintained between uninsulated live parts of opposite polarity and between

uninsulated live parts and dead metal parts.

Sharp Edges – This appliance shall have no sharp edges, points, or

spikes inside or outside the appliance that may cause injury during use,

including cleaning.

Electrical Connection – Unless specified otherwise, all wire connectors

are R/C (RFWV2), Quick-Connector Terminal, R/C (ZMVV2)/CNR or Listed

(ZMVV)/CN devices, rated 105C, 600 V. Connectors shall be suitable for the

number of conductors, size, and material of conductor involved.

Internal Wiring - Unless otherwise noted, all fiberglass coated

internal wiring is R/C (AVLV2)/CNR, minimum 20 AWG, rated minimum 200°C, 300

V, VW-1.

Insulation Sleeving – Unless otherwise noted, sleeving is Sleeving,

Coated Electrical, R/C (UZFT2), rated minimum 150°C, 300 V. Minimum wall

thickness of 0.4 mm, unless otherwise noted.

General Markings – The Listee’s name or trademark, the electrical

ratings, the catalog number, and the date code are marked on an R/C (PGDQ2/8)

label suitable for use with the surface to which it is applied and rated

minimum 60C. Or marked on the surface of appliance by die-stamped, molded,

etched, silk-screened. The marking label, if provided, was located on the

Terminal Block Cover.

Tsannkuen’s Confidential Data. Provided on 2021/05/11 for Storebound inspection reference only. Other usage is forbidden.