Marketing Materials

File E81296 Vol. 1 Sec. 591 Page 2 Issued: 2021-03-18

and Report

CONSTRUCTION DETAILS:

Section General – The following construction items are described in the

Section General:

Mechanical Assembly Corrosion Protection

Soldered Connections

iring Terminations

Markings Instruction Manual

Date Code Polarization Instructions

Carton Markings

For details of the construction, refer to the following photographs and

descriptive pages.

Canadian References – In this report, “CN” denotes that the component

is CUL or CSA Certified. If the unit does not bear the CUL Mark, the “CN”

reference should be disregarded.

Spacing - Minimum 1.6 mm spacing are maintained between un-insulated

current-carrying parts of opposite polarity and between current-carrying

parts and dead metal for both USL and CNL, except for CNL, minimum 3.1 mm

spacing are maintained between un-insulated current-carrying parts and a

conductive enclosure.

Sharp Edges – This appliance shall have no sharp edges, points, or

spikes inside or outside the appliance that may cause injury during use,

including cleaning.

Electrical Connection – Unless specified otherwise, all wire connectors

are R/C (RFWV2)/CNR, Quick-Connector Terminal, R/C (ZMVV2)/CNR or Listed

(ZMVV)/CNL devices, rated minimum 105°C, 125 V. Connectors shall be suitable

for the number of conductors, size, and material of conductor involved.

Internal Wiring - Unless otherwise noted, all fiberglass coated

internal wiring is R/C (AVLV2)/CNR, minimum 18 AWG, rated VW-1, minimum 200°C,

300 V.

Insulation Sleeving/Tubing – Unless otherwise noted, sleeving is

Sleeving, Coated Electrical, R/C (UZFT2)/CNR, rated minimum 150°C, 125 V, and

tubing is Tubing, Electrical, R/C (YDPU2)/CNR or R/C (YDTU2)/CNR, rated

minimum 105°C, 125 V.

For Storebound Inspection Only. Other Usage Is Forbidden!