Installation Manual

Special Installation Notes -
• If your DashMat seems too big and/or hangs over the front of
the dash:
A - Be sure the mat is pushed all the way back between the glass and
the dashboard. The vent cutouts should match the defrost vents.
If necessary, use a wooden ruler or paint stick to push the mat into
place.
B - Because of auto assembly tolerances or variations in the position of
replacement windshields, DashMats may require trimming on the
windshield edge.
• If the fastener strips won't stick to the dash:
The adhesive backing won't stick to a dashboard that is dirty, dusty or
has vinyl or polish protectant applied. Thoroughly clean all areas with a
mild detergent or rubbing alcohol (see step #2 on page 1).
• What about radio speakers?
Speaker areas need extra protection from the sun so we do not cut out
for them. The sound comes through the DashMat fine --just try it and
see!
• Climate control sensors / Alarm sensors / Automatic head-
light sensors:
The DashMat is usually marked for these on the underside, but not
usually pre-cut. After checking the automatic headlights, digital climate
control or alarm sensor markings against the actual sensor position,
you may cut the marked area with a sharp utility blade or scissors.
Remove the DashMat from the dashboard before cutting.
• Optional center-dash clocks and displays or side window
defrost vents:
The DashMat is often marked for these but not pre-cut. If your vehicle
requires the cutout, use scissors or a utility blade on the lines indicated.
Remove the DashMat from the dashboard before cutting.
• Plasticizer Migration:
A few car models are known to have this problem. This occurs when
the plastic formulation inside the dashboard begins to break down and
migrate or flow. This results in a darkened burnt-looking area appear-
ing on the top of the dashboard. This indicates a weakness inside the
dashboards of certain model years (primarily older vehicles) and may
occur on both covered and uncovered dashboards. DashMat assumes
no responsibility for such incidences.
ATTENTION: Your DashMat has been manufactured to allow for
proper deployment of the airbag safety system. Special design and
cutting allowances for the DashMat have been made so as not to
restrict the passenger side air bag system. You must not apply any
fasteners to this area since they could (or would) restrict proper
airbag deployment.
DashMat assumes no responsibility for incorrect installation or
alteration of DashMat products resulting in improper airbag
deployment.