Installation Manual

Printed in USA Form # 500099 (01/10)
LIMITED WARRANTY
DashMats are warranted from date of purchase to the original purchaser.
Save your receipt! Warranty coverage protects against defects in material and
workmanship, as well as the fabric becoming unserviceable during normal use.
Original DashMat® (Foss Fiber® carpet) - Limited Lifetime Warranty
UltiMat® - Limited Lifetime Warranty
VelourMat™ - Limited Two (2) Year Warranty
SuedeMat™ - Limited Two (2) Year Warranty
Ltd. Edition - Limited Two (2) year Warranty
After factory inspection, we will repair or replace the DashMat.
Warranty does not cover fading, which occurs naturally
on all products subjected to prolonged UV sun exposure (except Original
DashMat Foss Fiber which is warranted fade-resistant to the original purchaser).
To process your warranty claim, contact:
Customer Service - DashMat Division
100 Enterprise Blvd.
Pauls Valley, OK 73075
405-238-9651 M-F 8AM to 4PM CST
[e-mail]
Installation Instructions & Tips
How to Install -
1 - Unroll the DashMat
Allow it to lie flat overnight if possible.
2 - Clean Your Dashboard Area
Wipe off dust and grime. Use a small rag
and denatured or rubbing alcohol to re-
move any vinyl protectants, polishes,
waxes or preservatives from the areas
where you will place the self-adhesive
"hook" fasteners. NOTE - First test the
rubbing alcohol on an unseen location of
the dash to make sure there is no reaction
with the vinyl. If there is a reaction, clean
with a mild detergent instead.
3 - Set the DashMat in Place
Make sure the defrost vent cutouts align
with the vehicle defrost vents. On some
cars, the material must be pushed forward
between the dash and the windshield.
Use a wooden ruler / paint stick if neces-
sary.
4 - Pre-Shape
Speed up the shaping process by bending
and/or creasing the DashMat to help it
conform to the curves and indentations in
the vehicle dash.
5 - Applying the Fasteners
After the DashMat is in place and has been shaped by hand, cut the self-adhesive
hook fasteners into 1" long pieces and apply the fasteners where needed on the
dashboard. Press the DashMat down onto each fastener. Normally a few fasteners
applied near the windshield -- at each side of the dash, around the front edge at the
instrumentation and passenger side at the contours -- will hold the DashMat in place
while it shapes to the
dash. If you wish to
remove a fastener,
peel it slowly away from
the dashboard to avoid
marring the vinyl.
1
2
3
4
5