User manual

- 8 -
1）Wall mount picture： 2）Ceiling mount picture
★Note: Ceiling mount can’t be installed outdoor without waterproof protection; otherwise,
the speed dome will be damaged by water leaking. If any special requirement, please
refer to ceiling mount outdoor installation manual as attachment.
4.2.1 Wall Mount Installation
Installation condition：
Wall mount high speed dome camera an be used in hard wall structure both indoor and
outdoor
⑴The thickness of the wall should be enough to install expansion screw
⑵The wall can withstand at least four times the weight of the dome
High speed dome camera assembly instruction：
Step1: Please unpack the camera
Note: to prevent foreign objects from touching the transparent cover, protect and
transparent cover!
Step 2: take out production foam
Note: to protect the camera and the module, it is important to ensure the protection foam
vertical slow out, can not be tilted too far, otherwise a scratch may occur.
Step3: install the transparent cover
Install the camera module to high speed dome camera. Point the gap at the waist-hole,
and then use a cross screwdriver to install two stainless steel screws M4 × 6. Note avoid
anything touch the transparent cover, please protect the transparent cover.