User Manual

WMTS TRANSCEIVERS
PatientNet Operator’s Manual, v1.04, 10001001-00X, Draft 203
All information contained herein is subject to the rights and restrictions on the title page.
Use and Maintenance
Connecting to the Bedside Monitor
See Figure 92 on page 200 for an image of the DT-7000/DT-7001 controls and LED
indicators.
Note: Before the transceiver is connected to the bedside monitor, the system
administrator must program it with the bedside device specific software
module.
1. Attach the transceiver to the bedside monitor by sliding the Device Hook over
the Mounting Disk until the transceiver snaps into place. The Mounting Disk
is provided with the transceiver and is attached to the bedside device through
adhesive or hardware tools.
2. Connect the AC power adapter into the power port located on the bottom of
the transceiver.
3. Plug the AC power adapter into the wall electrical outlet. If the AC power
adapter is not used, the transceiver will operate either from its internal battery
(DT-7001 models) or, on some bedsides, from connection to the bedside
device.
4. Attach the host end of the I/O cable to I/O port 1 (Ports 2, 3 and 4 will be
functional in future releases).
5. Attach the other end of the I/O cable to the bedside monitor.