Service Manual

AlarmView™ Service and Installation Manual
Page 41
To launch the Configuration Program, tap the Programming
button. The “Configuration Program” Main Screen will appear.
This program is used to change the transmitter’s setup of bed
numbers, cap codes, alarm severity, and reminder page interval.
It also displays information that can not be modified by the user.
This information includes: monitor identifier (N3000, N295,
N290), transmitter number, hardware version, software version,
protocol version, authorize identification, paging frequency, and
paging baud rate. This program can be used at shift change, or
whenever there is a need to change/view the current transmitter
configuration.