Service Manual

AlarmView™ Service and Installation Manual
Page 55
Communicating With
Patient Monitoring
Equipment
Turn on the transmitter, as described above. Attach the serial
cable to the RJ-45 port. Attach the other end of the cable to the
patient monitoring equipment. The transmitter will automatically
detect the monitor (assuming it is an N-3000, N-295, or N-290).
Once communications have been established with the patient
monitoring equipment, a page will be sent to the pager indicating
this, and the LED will turn GREEN.
The communications established page will have the following
data:
Bed: xxxxx
Comms OK
<Insert photo and or screen shot here>
From that point, all alarms at the patient monitoring equipment
will be sent to the pager(s), as assigned by the PDA (as
described above).