Service Manual

AlarmView™ System User’s Guide
{insert part #} Page 28
Changing Pager Assignments
One, two, or all pagers can be assigned to each transmitter. To
change alarm destination and pagers assigned to a transmitter:
1. From Alarms screen, tap button for Assigned Pager or All
Pagers.
2. Tap Pagers tab to move to pager selection screen.
{insert pager selection screenshot (Figure 6-6)}
Pager Selection Screen
3. Tap Down Arrow in First Pager field and tap to select cap
code for desired pager.
4. If another pager is desired, tap Down Arrow in Second
pager field and select cap code for desired pager.
5. If all pagers is desired, tap button for All Pagers.
!!
!!
!!
You can choose the All Pagers option from the Alarm screen or
the Pagers screen.
Assigning All Pagers from Transmitter
The All Pagers option can also be selected from the transmitter
without using the programmer. Transmitter should be on, but not
communicating with a monitor.
1. Turn transmitter on, but turn monitor off or disconnect
interface cable. Mode LED should be Amber.
2. Turn on at least two pagers in system.