Service Manual

AlarmView™ System User’s Guide
{insert part #} Page 39
Turn on all transmitters, and ensure they are not communicating with
monitors. When the transmitter you are testing sends a survey page,
the other transmitters’ Mode LEDs should flash Amber. This should
be seen at regular intervals as the survey page continues.
If no dead spots are discovered and the transmitters can detect each
other, the transmitter range test is complete. Contact Data Critical Corp.
if dead spots present a problem in functioning of care unit.
Periodic Maintenance
Batteries
Transmitter
At least every two years, the transmitter’s internal battery should
be tested. To check transmitter battery performance:
{Placeholder for procedure to test battery performance from LL}
Programmer
To recharge programmer main battery pack and replace
programmer backup battery, refer to Appendix B: Basic
Programmer Functions in AlarmView System User’s Guide.
!
!
!
If main battery warning message is displayed, recharge main battery
as soon as possible. If both backup battery and main batteries are
depleted programmer software and data will be lost.
Pager