User Manual

AlarmView™ System Administrator’s Manual
880-0326-01 REV. A Page 14
Rear Panel
Transmitter Rear View
Monitor Input and Power Input ports.
WARNING: In the USA, do not connect the AlarmView transmitter
to an electrical outlet controlled by a wall switch, because AC power
may accidentally turned off.
WARNING: To ensure patient safety, do not place the AlarmView
transmitter in any position that might cause it to fall on the patient.
WARNING: Do not lift the monitor by the sensor cable or power
cord, because the cable or cord could disconnect from the monitor,
causing the monitor to drop on the patient.
Programmer
The AlarmView Programmer is a handheld computing device, or
personal digital assistant (PDA), that is used to setup and
change the configuration of the AlarmView transmitter. Data is
exchanged between the transmitter and the programmer via
Infrared (IrDA) ports on both the programmer and transmitter.
The programmer is to be used for the AlarmView System only.
Programming that is not used for the AlarmView System has been
disabled. Do not attempt to load, enable, or use other software with
the programmer, as it may corrupt or damage system software.