User Manual

AlarmView™ System Administrator’s Manual
880-0326-01 REV. A Page 23
Although the transmitter can operate on its internal backup battery
for a short period of time (up to 45 minutes under normal operation),
always use AC power when possible.
Connect to Monitor
1. Connect the modular RJ-45 plug end of the interface cable
to the input port on rear panel of transmitter.
Monitor Input Port
2. Connect the other end of the Data Critical interface cable to
the data port on the rear of monitor.
A Data Critical serial cable with a 15-pin (Male DB15)
connector is required to connect to NPB-290, NPB-295, and
N-395 monitors. A Data Critical serial cable with a 7-pin
(male 7 pin DIN) connector is required to connect to N-3000
monitor.