User Manual

AlarmView™ System Administrator’s Manual
880-0326-01 REV. A Page 38
!!
!!
!!
You can choose the All Pagers option from the Alarm screen or
the Pagers screen.
Assigning All Pagers from Transmitter
The All Pagers option can also be selected from the transmitter
without using the programmer. The transmitter should be on, but
not communicating with a monitor.
1. Turn transmitter on, but turn monitor off or disconnect
interface cable. Mode LED should be amber.
2. Turn on at least two pagers in system.
3. Press and hold transmitter On/Off button until an All Pagers
confirmation message is received at pagers (approximately 5
seconds).
Bed: 1234
Programming OK
All Pagers
Programming New Data into Transmitter
Bed number and pager assignment changes made in the
previous steps should now be programmed into the transmitter.
!!
!!
!!
Once data has been retrieved for a transmitter, it is easiest to
change all values for that transmitter before sending changes
back to transmitter.