User's Manual
PhysioTelDigitalConfigurationManual Software•35
1. The data acquisition computer sends an implant Mode Change command to the CLC.
2. Ponemah starts displaying a countdown in the Implant Status screen.
3. The CLC configures the implants and sets the implant mode to Active.
4. The computer updates the implant status to Acquiring.
5. The implants start sending data packets to the CLC.
6. The CLC starts sending data packets to the computer.
7. The computer sends the data to Ponemah.
8. Ponemah begins displaying waveform data in P3P graphs.
Diagnostics
Accessing Diagnostics
The Diagnostics user interface is a browser based webpage that allows the user to check the status of the
PhysioTel Digital hardware components, update firmware, and perform diagnostic tests to optimize the
performance of the system components.
The Diagnostic user interface is accessed from the Ponemah Hardware menu.
•
From the menu bar click Hardware, and select Diagnostics.
• This opens the Diagnostics Webpage in a dedicated browser window.
Diagnostics Webpage
The Diagnostics user interface is a browser based webpage that allows the user to check the status of the
PhysioTel Digital hardware components, update firmware, and perform diagnostic tests to optimize the
performance of the system components.
To select a specific CLC click on the drop-down menu located in the top left corner of the diagnostics
window. All of the configured CLCs that are connected to the system will appear in this list.