Instruction manual

28
Item Illustration Function Description
1
Color Bar Setup
(MODE)
Use the MODE button to setup and adjust
the screen brightness and color density.
2
PAN/ TILT Control
(RESET)
Press RESET button to face the camera
back to the front.
3
Camera Select
(CAM1~CAM4)
Operating more than one camera with
the Remote Controller.
 Set the IRID (SW2) switch (at the rear of
the main unit) of the camera which you
intend to operate: 1/ 2/ 3.
 Press a CAMERA SELECT (CAM 1~ CAM
4) button (on the Remote Controller) which
corresponds to the number set in step 1.
After the above setup you will be able to
operate the camera (s) specified by
number.
4
Position Setup
(0~9)
(PRESET)
(SET)
Up to 32 combinations of settings (position,
zooming, focusing, gain control and iris
control) can be preset.
Adjusting the Preset Point
Adjust the position, the zooming, the
focusing, the gain control and the iris control
of the camera.
Setting up the Preset Point
Press any of the POSITION buttons 1~32
and then press SET button.
Recalling the memorized setting
Press any of the POSITION buttons 1~32
and then press PRESET button.
Setting up the Group Scan mode
Press any of the POSITION buttons 1~8
and then press MENU button.
To face the camera back to the front
Press the number 0 and then preset button.
5
Focus Setup
(FAR)
(NEAR)
To focus the camera on a subject
manually
Press either FAR or the NEAR button to
have the camera focus on the subject
manually.