Installation manual

Maxsys and MX Series Software Administrator’s Guide 139
Configuring the MXi Envelope Inserter
Set up jobs for the envelope inserter option on your MXi system using the PFE
Maximailer documentation before completing the MXi configuration in the
Maxsys/MX Series Form Setup.
If you are not using selective inserts, skip to "Configuring MXi in Form
Setup" on page 142.
Setting Up Selective Inserts on the MXi Controller
If you are using selective inserts, use the following procedure to modify an
existing job setup.
1. O
n the MXi Controller Run screen, select the Setup Screen icon in the upper
right corner (next to the X).
2. Select Configurations from the left-hand side of the screen. Select the
configuration that applies to your job, and then select Edit on the bottom
pane. A graphic view of the MXi system is displayed.