Installation manual

202 Hex Dump
Go To Offset
Perform the following steps to use the Hex Dump Go To Offset tool:
1. To search
the data using the Go To Offset tool select Edit | Go To Offset
(Ctrl+g).
2. Select an Offset Value Type:
• He
xadecimal - Enter a hexadecimal number no bigger than the one stated
in the dialog box.
• De
cimal - Enter a decimal number no bigger than the one stated in the
dialog box.
3. Cl
ick OK to continue or Cancel when finished.
4. When a valid offset value is enter
ed, a block or record is shown within two
offset position markers (I bars) in the Hex Dump Viewer display.