Installation manual

258 ConCAD
Layout Properties
Use Layout Properties to define the features of the layout. To access right-click in
the page area where there is no element and then select Properties from the
menu. From the layout properties tabs, define the properties for the layout. Each
field is described in detail below.
Front/Back Surface
Select Back Surface on the back surface tab to enable a two-sided layout.
If both front and back surfaces are used, it is best to also select Produce
Backside First for better throughput.
Surface Size
Size can be set by manually by entering the x (width) and y (height) parameters
measured in millimeters, or by selecting a preset value for cards or
passports.Both front and back surface sizes must be set.
ID1 (default card) ID3 (default passport)
ID3p (passport portrait orientation) ID3 (passport double page)