Installation manual

268 ConCAD
Processing Tab
This tab is common to all elements in a laser template.
•
Horizontal axis
• Vertical axis(MX6000)
• No Tilting (default) - If “No Tilting” is set the track
bar will be disabled.
• Lase element further away from beamtrain
• Lighter image
• Larger laser dots
• Blurry
• Lase element closer to beamtrain
• Lighter image
• Smaller laser dots
• “Pixel” appearance
• Burning
• Gray areas outside of bitmap areas
• Lines in images
Tilting Axis/Angle The direction and degree to which the product is
angled during element lasing. Values:
Note: Tilting is used for lasing special lens structures.
Process Distance If a process distance other than 0 is chosen, the
product gets lased out of the defined laser working
plane (distance of the product from the laser beam
train).
By using this, you can lase an element either further
away from (process distance > 0) or closer to (process
distance < 0) the beam train.
This has several effects on the appearance of the lased
object, depending on other settings and the actual
material behavior.
Process distance > 0
Process distance < 0
Range: -
30 to 30
Pixel Repetition Laser pulse repetition at every pixel multiple times. The
result is a much darker mark. Generally should not be
used.
Range: 1 to 4294967295
Reset All Sets the default values for all three properties.