Installation manual

Maxsys and MX Series Software Administrator’s Guide 269
Bitmap Settings Tab
This tab is common to all bitmapped elements.
Alignment Point The x/y coordinate (mm) to which the image is aligned.
Horizontal Pos. Horizontal alignment (left, center or right) with the
alignment point.
Vertical Pos. Vertical alignment (top, middle or bottom) with the
alignment point.
Rotation Rotation of the image (range: -180 to 180 degrees)
around the alignment point
When rotating an element, the laser line or scan
direction will also change.
Shear Adjustment for shear on either the x or y axis.
Output DPI Integer between 0 and 16000 or Auto.
Output DPI y Ability to set the resolution in y direction. Available only
when using Mode 5 (Independent y resolution). See in
“BMP Laser Details” on page 270
Crop White Space By default cropping is enabled on all sides.
Alpha Blending Select Alpha Blending to enable Alpha Channel feature.
See “Alpha Channel” on page 259.
Read Only: Bitmap
Output Size
The x/y dimensions (mm or pixels) of the bitmap.
Enhance Edge Selection of this feature uses different laser settings to
increase contrast at gray level edges, for example at a
white-to-black or black-to-white transition. It is
recommended for most types of elements containing
black and white content (few or no gray pixels).
Examples include text, barcodes, signatures, and logos.
It should not be used for portraits.
Enhance edge mode may be slower than non-
enhanced edge mode.
Note: Enhance edge is activated by default for
bitmapped text and barcodes, deactivated by default
for bitmap images.
Negative Inverts the gray levels of the image (black = white; white
= black)