Installation manual

Maxsys and MX Series Software Administrator’s Guide 17
Filter Tool
If the selected job contains a large number of cards, use the filter tool to limit the
number of cards displayed. The tool consists of a list of record numbers and range
parameters at the bottom of the Job List pane.
For example, to view records 2700 to 2800 of a job that contains 10,000 cards,
select Record No.
from the list, enter the range (2700, 2800) in the Single Value or
Range boxes, and then click Search. Click Clear to clear the search results and
display the full job details.
To search for a single record, select Record No. from the list and then enter the
record number in the first of the two range fields and click Search. Click Clear to
clear the search results and display the full job details.
Filtering categories (record number, state, status, etc.) are defined in the
Data Setup.
Choose Columns to Be Displayed
Use Choose Columns to select the columns to be displayed on the Ready Jobs, All
Jobs, or Job Details tabs of the Production station.
Privileges for this option may be defined when security is enabled; refer to
Chapter 14: “Security Configuration” on page 203.
Perform the following steps to view or hide columns:
1. Select the Ready Jobs, All Jobs, or Job Details tab.
For Syntera-enabled workstations, select the Job Details tab.
2. Click Choose Columns (or Columns for Syntera-enabled workstations) on
the bar above the job list.