Installation manual

280 ConCAD
Vector Settings Tab
Vector elements are available for laser templates only. The vector settings tab is
common to all vector-based images.
Vector Mode
Black line Results in a solid, non-tactile line, depending on laser
settings and card material.
Tactile line A tactile vector is a vector that is lased so that the
material actually breaks up. This results in a tactile
surface (when moving your finger over it you can feel
it), depending on laser settings and card material.
Manual Manually enter all settings (see below).
Fill Mode (enabled if Vector Mode is set to “Manual”)
Hatch Hatching is a technology used to automatically
produce vectors of a certain line width. Small vector
lines are produced orthogonal to the vector direction.
Wobble A technique to lase thick vectors. Normally the laser
produces a very thin line. By wobbling, the line can be
made thicker or stronger.
The laser beam rotates along a line in a spiral
movement with a certain amplitude (spiral diameter =
line thickness) and frequency (Wobble Frequency).
No Filling No filling will occur.
Settings
Line Thickness (mm) Line thickness, must be entered manually.
Point Density (dpi) Enabled if Vector Mode is set to “Manual”. DPI values
can range from
0 to 4294967295
Wobble Frequency (Hz) Enabled if Fill Mode is set to “Wobble”. See the
description for “Wobble” above.
Vector Power Enabled if Vector Mode is set to “Manual”. The
selected laser power level for this vector.