Installation manual

Maxsys and MX Series Software Administrator’s Guide 281
Vector Line Element
This tab allows you to define x/y-coordinates for the line's start and end points.
Vector Rectangle Element
Start Point Define the x/y coordinates for the start point.
End Point Define the x/y coordinates for the end point.
Read Only
Properties
Length and angle of the vector line.
Base Point The position of the base corner (bottom left) corner of the
rectangle (P
0
)
Size The size of the shape (in mm).
Rotation Angle The number of degrees the shape will be rotated.
Laser Processing
Order
Starting Corner - The corner where the lasing starts
(typically P
0
=base point, see above - P
1
, P
2
, P
3
are the
other corners in a counterclockwise direction).
Direction - The direction the rectangle is drawn originating
with the starting corner.