Installation manual

Maxsys and MX Series Software Administrator’s Guide 285
Perforated Number Element
The dot matrix font is only used with Number Perf layouts. To create a number
perf layout, you must enable a number perf module (PB6500):
1. Right-click the background of the card/passport surface and then select
Properties or click the yellow layout properties icon in the toolbar
2. In the Available Modules box, enable Number Perf.
Alignment Point Location (x/y coordinates) of the top-left number
string.
Text The text to be lased.
Font The font that will be used.
Dot Spacing The amount of horizontal (x) and vertical space (y)
between the perforated dots. Based on the x value,
selecting Default Ratio will change the y value to
create the standard x: y ratio.
Space Between
Characters
The amount of space between the perforated
numbers.
Dot Diameter The diameter of the perforated dots.
Note: This setting is for ConCAD display purposes only.
The effective dot diameter is determined by the laser
power parameters and the material on which the
perforation is being made.