User guide

Initial Configuration 51

CONFIGURATION: For the connections to be properly set, use the syntax below in the Command

Line Interface (CLI) to setup Tap and Any-to-Any ports. As the IP address (default 192.168.1.1)

is set during the 'Initial Configuration' it is not covered in this section, see the 'IP Address ' section

for those steps. The connections in this exercise are setup in the CLI as shown below (syntax is

shown with either user > or Superuser # prompts):

For Initial Configuration, open HyperTerminal on your Management PC using the SS-1210BT-BT/

SFP-S SERIAL DB9 port. Settings are found in the 'Initial Configuration', 'SERIAL Port

Configuration (DB9)', 'HyperTerminal ' section.

Press Enter key, Enter key, then enter your Username (default: Administrator), Enter key,

Password (default: admin) and Enter key. Default prompt is the > symbol.

Then enter Superuser mode, at the user prompt >, enter SU, Enter key, and enter the Password

(default: password) and Enter key. Default prompt is the # symbol.

In Superuser mode use the following syntax for the different connections. This syntax sets the input/

output for Any-to-Any ports as well as the input/output for Tap ports.

The factory default for all aggregation taps (SS-1200-S series and SS-2200-S series) are

turned off by default - i.e. they are not set up as either inputs or outputs and are not

replicated to any other ports with the exception of the hard-wired in-line taps.