User guide

Application 77

Now you can begin setting the ports as to which port inputs the data and which ports aggregate and/

or output the data.

Port 5 is set as output for 2’s input which is set with this syntax:

# SET PORT MONITOR 5 FROM 2

Port 6 is set as output for 1’s input which is set with this syntax:

# SET PORT MONITOR 6 FROM 1

Port 7 is set as output for Port 4’s input which is set with this syntax:

# SET PORT MONITOR 7 FROM 4

Port 8 is set as output for Port 3’s input which is set with this syntax:

# SET PORT MONITOR 8 FROM 3

Port 9 is set as output for Ports 1,2,3 and 4’s input/output which is set with this syntax:

# SET PORT MONITOR 9 FROM 1,2,3,4

Port 10 is set as output for Ports 1, 2, 3, and 4’s input which is set with this syntax:

# SET PORT MONITOR 10 FROM 1,2,3, 4

CONCLUSION: The SS-2210BT-BT/SFP-S provides the ability to tap two network segments,

selectively determine how the traffic is combined and to which ports. Maximum flexibility is

achieved, since both links can be aggregated together and sent to multiple output ports. Additional

ports are available for devices that do not need to see both links or when troubleshooting specific

links. Ports 9 and 10 provide small form pluggable outputs for devices with fiber media. With the

factory default LINK PROTECT settings, if one side of the network traffic, through the SS-2200-

S is interrupted for longer than 10 seconds, the tap will enter bypass mode and the other side of the

network will also drop "LINK" with the integrated tap. See the SET LINK PROTECT section

for additional information.