User Manual

Figure 3 Figure 4
Parts Included:
1. Recessed Cable Plate with Power
2. Recessed Cable Plate with Straight Blade Inlet
3. 6 Ft. Extension Cord
4. Two (2) Old Work Electrical Boxes
5. 12 Ft. of Non-Metallic Electrical Wire
6. Three (3) Wire Nuts
Tools Needed
1. Drywall saw
2. 6 Ft. tape measure
3. Pencil
4. Screwdriver
Use the Recessed Pro-Power Installation Kit to install power and
low voltage cables behind your flat panel TV (see Figures 1 &
2), amplifier or other audio and video devices to your equipment
room or at the location of your head end equipment.
IMPORTANT INSTRUCTIONS:
 Use the local electrical code approved installation when
installing this product.
 The electrical parts in this kit are designed to be used
only as a kit and none of these electrical parts are
designed to be used individually.
 This product is not designed to be part of your home or a
commercial building’s electrical wiring system.
 This installation is only energized (electrically active)
when the supplied 6 ft. cord is plugged into the recessed
straight blade inlet located on the recessed low voltage
cable plate and the straight blade end of the 6 ft. cord is
plugged into either your surge protector or wall
receptacle.
 If you are not familiar with home wiring systems, please
call a qualified electrician to install this product.
Installation Instructions for New Construction:
Simply use a new nail on box and follow all other instructions
described in the retrofit portion of the instruction sheet.
Installation Instructions for Retrofit Only:
1. Select the location of your flat panel TV mounting
bracket. Now select the location for both the Recessed
Cable Plate with Power and the Recessed Cable Plate
with Straight Blade Inlet.
2. Both the Recessed Cable Plate with Power and the
Recessed Cable Plate with Straight Blade Inlet are
designed to be mounted between two studs (see
Figure 1). Using the template supplied (see page 2),
trace the openings needed for both recessed cable
plates. Using a drywall knife cut a hole in the drywall the
size of the template. Remember, these plates are
designed to be mounted between two studs.
3. Remember that the Recessed Pro-Power Installation
Kit is not part of your home’s electrical wiring
system. Before installing the single gang retrofit
workboxes (see Figure 2), pull a piece of 12/2 or 14/2
with ground UL approved building wire from one opening
to the other opening to connect the Recessed Cable
Plate with Power to the Recessed Cable Plate with
Straight Blade Inlet. Make sure the piece of wire is long
enough to allow for easy installation of the receptacles.
Insert a single gang retrofit workbox (see Figure 2).
Securely fasten the workbox to the wall.
DataComm Electronics, Inc.
6349 Peachtree Street
Norcross, GA 30071-1725
888.223.7977
770.662.8205
www.datacommelectronics.com
Instruction / Installation Sheet
DataComm Electronics 45-0023-WH-KIT Recessed Pro-Power Installation Kit
Figure 1 – Front View
Figure 2 – Back View
Page 1 of 2 8/5/11 Rev. 2
45-0023-WH-KIT