User Manual

DataComm Electronics, Inc.

6349 Peachtree Street

Norcross, GA 30071-1725

888.223.7977

770.662.8205

www.DataCommElectronics.com

Tools Needed

Philips Head Screw Driver

Hammer

Installation

1. First determine the location for the Mini Rough-In Box with Brush Plate

2. Remove brush plate cover from the mini rough-in box

3. Nail box onto the stud during rough-in phase and run cable through the box

4. After drywall is installed cut a 1.70” x 1.70” hole in the install location

5. Run cable through brush pass-through opening

6. Place brush plate back onto the rough-in box

Instruction / Installation Sheet

Mini Rough-In Box with Brush Plate

Part # 45-0007

Caution:

• Never install low voltage wiring during lighting storms.

• Never touch un-insulated wires or terminals unless the wire has been disconnected at its network

interface.

• Use caution when installing or modifying data or telecommunication lines.

• DO NOT alter, change, or disconnect existing telecommunication wires if you are

unsure of their purpose or function.

• It is NOT recommended to install this product in close proximity to an electrical service

panel to prevent interference from electrical current.

Important Instructions:

• Read and understand all instructions.

• Do not use this product near water, for example near bath tub, wash bowl, kitchen,

sink, or laundry tub, in a wet basement, or near a swimming pool.

• SAVE THESE INSTRUCTIONS.

• This product is designed for use with low voltage cables ONLY.

• DO NOT run or pull a TV cord or other electrical cords inside the wall.

• It is a violation of the National Electric Code (NEC) to run power cords or

extension cords behind the wall.

Template for

drywall cutout

45-0007

1.70”