User guide

Installing Cable Management Assembly
96-30052-001 Rev. A4 DataDirect Networks StorageScaler 8460 User Guide | 26
3. Wrap a velcro strap around the last link of the basket as shown in Figure 25.
4. Repeat Steps 1 to 3 above to insert the SAS cables and power cable into the other CMA.
2.4.2 Attach CMAs to Rack Rails
After you have inserted all the cables in both baskets, follow these steps to attach the CMAs
to the rack rails:
1. Slide the enclosure out from the rack by pushing in the two release tabs on front of the
enclosure. Keep pulling until the enclosure locks and you hear a clicking sound.
2. Hold the left CMA close to the left rack rail and route the long end of the cables through
the hole in the rack rail (Figure 26).
Figure 25. Velcro Strap on Cable Management Assembly (Left CMA Shown)
Velcro Strap
Figure 26. Put Cables through Hole on Rack Rail