User guide

Installing Cable Management Assembly
96-30052-001 Rev. A4 DataDirect Networks StorageScaler 8460 User Guide | 27
3. Hook the flanges of the first link of the CMA under the rack rail (Figure 27). Then align
the slots on the first link of the CMA with the embedded keyhole fasteners on the rack
rail and slide the CMA forward. Tighten the thumbscrew finger tight.
4. Attach the CMA cross bar to the rear panel of the enclosure using two #10-32 screws as
shown in Figure 28.
5. Repeat Steps 2 to 4 above to attach the other CMA to the rack rail and rear panel of the
enclosure.
6. Depress the locking tab on the enclosure rails and carefully push the unit back into
place until the front release tabs engage.
Figure 27. Attach CMA to Rack Rail (Left Side Shown)
Thumbscrew
Insert Thumbscrew Here
Figure 28. Secure CMAs to Enclosure